Where the vapor turns back to liquid
The condenser is where the magic of distilling happens: hot vapor meets cool copper and turns back into liquid. A traditional worm condenser does this through a copper coil. If yours is damaged, or you're building or upgrading a setup, you can buy just the condenser instead of a whole system.
What you're getting
Each listing is a condenser only. No pot, column, thumper, cap, or other accessories are included. Sizes are offered for 3, 6, 10, 15, 20, 25, and 30 gallon setups.
Walkthrough: swapping a condenser
- Choose the size that matches your still.
- Let everything cool, then take off the old condenser and look over the connections it attached to.
- Set the new condenser in place and connect it to your still.
- Do a water run before anything else. Watch for leaks, check the cooling, and make sure the outlet flows steadily.
Cleaning and maintenance
A coil is hard to see inside, so rinse it thoroughly after each run and let it drain and dry before storage. Copper darkens over time, and that's normal. Look over the coil and joints regularly, just as you'd check any part of your rig before a session.
Good reasons to buy one alone
Replacing a broken unit, upgrading an existing copper still, building a custom or DIY setup, or just saving money by buying only the part you need.
Stills are used for water, essential oils, and fuel alcohol with a permit. Distilling alcohol requires federal TTB permits. Always follow federal, state, and local law.
